Elements - Acrylic Sealant Siliconized Duct Seal 36-18 - One Component - Available In Multiple Colors

Brand: Elements

ELEMENTS D3618 Acrylic Sealant is a water based general-purpose, paintable sealant that is used for caulking, grouting, jointing, and embedding in building construction. It is easy to apply and compatible with most materials used in construction e.g. concrete, wood, brick, natural and artificial stone, metal, and sanitary ware. Acrylic is flexible and resists cracking, giving a smooth finish that is suitable for interior and exterior use.

Properties

Over paintable in one hour.

Flexible with low VOC.

Provides a smooth finish.

Water based and non-toxic.

Field Of Application

ELEMENTS D3618 Acrylic Sealant is ideal for sealing low movement joints, as a flexible crack filler before painting jobs, for sealing construction frameworks e.g. between window and door frames and walls: Suitable for Duct seal Joints, also suitable as an adhesive for bonding. If there is any uncertainty regarding the application, adhesion tests should be carried out.

Limitation

Not to be used where high movement accommodations is needed. Not to be used on oily, bituminous substrates, rubber or materials that may bleed oils, plasticizers, or solvents. Not recommended for use in floor joints, as a glass sealant, or joints subject to continuous water immersion. When using mastic acrylic do not expose to water or rain for at least 24 hours. Will not adhere to some plastics such as polyethylene, polypropylene, and Teflon.

Safety Instructions Elements

D3618 Acrylic Sealant is non-toxic. Avoid contact with eyes. In the event of skin or eye contact, rinse thoroughly and immediately with water. Seek medical assistance if irritation or discomfort persists. Keep out of reach of small children! Refer to our Safety Data Sheet for further toxicological information and comprehensive handling instructions.

Product Characteristics

Type:                                                                            Acrylic

Appearance:                                                                 White homogenous non sag paste

Skin formation / Tack Free time Approximately:            10-12 minutes Max

Ph:                                                                               6.0 – 7.0

Odour:                                                                          Mild

Solids (%):                                                                     Approximately 80-85

Viscosity:                                                                      Thixotropic consistency

Specific gravity (DIN 53479) (ASTM D792):                      1,60±0,03 g/cm³

Typical Performance Data

Application temperature:                                               Min. 5°C to Max. 50°C

Coverage:                                                                      Approx. 18-20m (4 x 4 mm)

Service temperature range:                                           -10 to 80°C

Modulus at 100% elongation [ASTM D412]:                       ≥0.2 N/mm²

Elongation at break [ASTM D412]:                                   ≥100%

Curing time:                                                                   48 hours per 2mm (25°C, 50% RH)

Shore A hardness [ASTM D412]:                                        30 ±2 H

Coverage

Point Width:                                                                   6mm     8mm   12mm 18mm

Joint Depth:                                                                   6mm     6mm    8mm   10mm

Joint Length In linear Meter 280ml Cartridge:                  7.7m     5.8m   2.9m    1.5m